A DIY generator has the ability to create electricity with simple equipment. The best tips for making a DIY generator start with the purchase of a bulb, magnetic wire, magnets, and a nail as well as a cardboard box. Then divide the box into five sections and place a nail in the box’s center. Next, expose the copper underneath the magnetic wire by stripping the edges and connect it to a lamp’s wire. Be careful to ensure the two ends do not touch, and twist the nail to produce light in the bulb.
Generators are machines that produce electricity. A DIY generator is relatively simple to make and will perform the same task regardless of its size. It is best to start with a small-scale generator as a test of building skill before attempting something more ambitious.
The equipment required to create a DIY generator should be easy to find. This includes 200 feet (60 meters) of magnetic wire, four small magnets, one nail, and a 1.5 volt bulb. A piece of cardboard 12 inches (30 cm) long and 3 inches (8cm) wide is also necessary. It is possible to use wood instead, however.
Use the cardboard to create a box. The box should be divided into five sections before being folded as follows. Two of the panels should be 3 inches (8 cm) by 3 inches, two others should be 3 inches by 1.5 inches (4 cm), and the final panel should be 3 inches by 2.5 inches (6 cm). Make sure one of the 3 inch by 3 inch panels overlaps the last panel. Use sticky tape to keep the box together.
Find the center of the DIY generator box and drive the nail through it. Widen the hole so that the nail is able to move without being stuck. Take the wire and stick one end to the box while wrapping the remainder around the nail. Four inches (10 cm) of wire must be left sticking out.
Expose the copper part of the wire by removing the cover from its ends. Tug on the wires in the hole to ensure the nail will easily be able to fit through. Put two magnets on each side of the nail and test to make sure the nail can still move freely.
Find a lamp and connect the DIY generator wire edge to the end of the lamp wire. To prevent the two connections from meeting, twist the ends together. To light the bulb, twist the nail rapidly. Use a hand crank drill to produce a greater level of electricity.